The product page for the industrial cardboard shredder lists manufacturing plants as one of the five applications, described as basic protection for light and heavy parts. The phrase small and medium factory is not on the page, and the description fits it anyway. A small and medium factory has the parts and the cartons, and it does not have the volume of a production line.


Start with the parts. The page describes the output as mesh and strips, and it describes the uses as filler, wrapping, and separation. A factory packing light parts uses strips to separate the parts in a carton, and a factory packing heavy parts uses strips under the part and mesh around it. The page states that the P80 can take a whole box at 20mm, which is the model for the heavier cartons that come with heavy parts.


The second part is the volume. The page states that desktop models are suitable for intermittent to moderate daily use, while floor-standing models are designed for continuous, repetitive operation. A small and medium factory sits between the two, and the P50 or the P80 is the model that fits the middle. The page describes the P50 at 18 m/min for single sheets and the P80 at 15 m/min for whole boxes, and the two speeds match two kinds of factory.


The third part is the power. The page states that P50, P50-X, P50-3 and P80 support single-phase 110V or 220V and also three-phase 380V, while P90 and P120 only support three-phase 380V. A small and medium factory usually has three-phase power in the production area and single-phase in the office, and the 550mm models fit both.


The fourth part is the space. The page notes that floor-standing packaging machines need additional floor space for safe feeding and material handling, but no dedicated room or structural modification. A small and medium factory has the floor space at the end of the line, and the machine fits that space without a building change.


The fifth part is the maintenance. The page states that daily maintenance is minimal, mainly keeping the feed area clean, regularly checking cutting components, and following standard cleaning guidelines. A factory with a small team does not have a maintenance department, and the routine is short enough for the line operator.


The sixth part is the shaft. Aircosan shafts are large, one-piece units rather than thin blades, designed for a service life of over five years and processed through lathe machining, high-frequency treatment, quenching, blackening, and multiple other steps. The material is 40Cr rather than ordinary 45# steel. 40Cr has lower brittleness and stronger impact resistance, and its machining time is more than twice that of 45#. At the same 550mm width, Aircosan shafts are visibly larger and thicker than thinner competing units and cost about 30% more, which shows in the overall machine weight. A factory packing heavy parts needs the shaft that resists the load.


The seventh part is the certification. The page states that the product passes CE, ROHS, and UKCA certifications, and holds an exclusive EU patent. A factory that supplies automotive, electronics, or export customers is asked for certifications, and the page lists them because the list is the answer.


What the page does not say is that the factory has to buy the largest model. It says the models differ in width and thickness, and the parts decide which model the factory needs.


Aircosan machines use overload protection, so when a jam occurs, the machine stops automatically and protects the motor. Aircosan machines have side sheet metal that fits tightly with no gaps, so paper dust cannot enter the gears and cause abnormal noise or long-term wear. Aircosan machines use a branded motor with ample power, so thick and hard cardboard feeds smoothly without repeated jamming at the inlet. Die life is generally 1.0 to 1.3 million meters depending on material and usage.


Aircosan runs its own parts processing factory, controlling part quality in-house rather than assembling from mixed outside sources. The company supports logo customization from one piece and color customization from ten pieces. After-sales responds within 12 hours and connects customers directly with engineers.


For a factory manager, the practical approach is to list the three heaviest parts and the three most fragile parts, and check each one against the thickness and the output form. The list decides the model, and the page has described the options.