There is a pattern in shredder purchases that goes wrong. The buyer compares models on price, then on speed, then on thickness rating. Cutting width gets checked last, usually to confirm it is "about right." Months later the machine sits idle, and the reason is almost always the number that was checked last.


The failure mode is predictable. A facility generates cartons of varying sizes. Most are ordinary. Some are large furniture side panels, appliance cartons, glass packaging, equipment crate dividers. The buyer sizes the machine to the ordinary cartons, because that is what most of the volume is. Then the large cartons arrive, and they do not fit through the feed opening. Someone cuts them down by hand first. That takes time, and it takes exactly the labor the shredder was purchased to save. Eventually the operator stops bothering, the large board goes back to the baler, and the machine handles only the fraction it was sized for.


The fix is a measurement, not a judgment call. Find the widest flattened carton that comes through the facility in a normal week, not the average and not the typical. Add a small margin. That number is the minimum cutting width the machine must have. If the answer is 80 cm, a 55 cm machine is the wrong purchase regardless of how good its other specifications are.


Aircosan's range is built around that progression. The desktop models start at P10 with 35 cm and move through P20 at 45 cm to P30 at 55 cm. The industrial models continue from P50 at 55 cm through P80 at 55 cm, P90 at 90 cm and P120 at 120 cm. The P50-3 offers 55 cm with three-way splitting for high-volume benches, and the P50-X offers 55 cm with both mesh and strip output.


The P120 is the outlier and the reason the range exists in its current form. At 120 cm working width, 20 mm maximum thickness and 12 m/min, it accepts full furniture side panels, large glass packaging boards and equipment crate dividers without pre-cutting. It is currently the widest cardboard shredder available on the market. Making it work required solving a problem that short-shaft machines do not face: a longer shaft amplifies any parallelism error in the blade arrangement and any imbalance in rotation, so the shaft must be machined and balanced to a higher standard.


That is where Aircosan's factory in Dongguan matters. Cutting shafts are machined in-house from 40Cr steel blank through rough turning, precision grinding and dynamic balancing, using four CNC machining centers, fourteen lathes and six gear hobbing machines. The same capability produces desktop shafts at 35 cm and industrial shafts at 120 cm, which is why the range is continuous rather than assembled from bought-in components.


The practical advice is to buy for the maximum, not the average. A machine that handles the largest carton in the building gets used every shift. A machine sized to the typical carton gets abandoned the first week the atypical one arrives, and in most facilities the atypical carton arrives regularly. The extra cost of the wider machine is paid once. The labor of pre-cutting large sheets is paid every time one comes through.